Build Log RV-10 #1

Blog for a Vans RV-10 Airplane Build

Pitch Servo Installation

Received the pitch servo and bracket so thought I would change course a bit and get that installed.  This was a very easy process. 

You start by simply attaching the servo to the bracket in the kit.  May want to prime this before.  Go the bolts in and I decided tie wire everything so that I know it will not come loose.

Take out the screws holding the pitch push rod and than reattach only this time put the bracket in first. Tighten per toque values.

Measure out the on the bellcrank where the the pushrod from the servo will be attached.  Installed the bolt and nut and that is about it.

For the wiring, I ordered a harness kit from Stein Air and will install once it gets here.

Click on images to view full gallery.